Description
"Sure, it's straight, but can you make it straighter?"- That simple statement started us on the path to make perfection even better. Not all reloading presses are created equal. In fact, a lot of them are about as crooked as the politicians you see blabbing on TV every day. Our Micro Die Adjuster Pro makes it easy to keep your brass straight with three attachment screws and a split ring design adjustment locking mechanism to perfectly align the die with the press ram.
For as long as we've been reloading we've always hated setting up our full length sizing dies. We've been using shims to help this along for quite a long while now, but have not really been pleased with them. It seems we always misplace them, or can't find the ones we need, or grab the wrong ones, and they always seem to be covered in rust. For as many years as we've been doing this we've always been looking for a better way. After searching off and on for a solution to this nagging problem we finally have a workable solution. The PMA Micro Die Adjuster.
The PMA Tool Micro Die Adjuster (MDA) replaces your existing lock ring and can be used with nearly any 7/8-14 full length sizing die. We successfully used this tool with sizing dies from Redding, RCBS, Hornady, Lee, Harrells Precision and those made from Newlon Precision die blanks. It allows you to easily make adjustments to your “shoulder bump” as fine as .0005”. The engraved marks on the MDA are equal to approximately .001” (true adjustment .000992”) of adjustment to the shoulder bump. Splitting the engraved marks is therefore approximately equal to .0005”. The design of the MDA does not allow it to work with the Forster Co-Ax press and is not intended for use with turret presses, progressive presses or the RCBS Summit press. Some custom dies for very short cartridges may require the use of an extended shellholder.
