Description
For as long as we've been reloading we've always hated setting up our full length sizing dies. We've been using shims to help this along for quite a long while now, but have not really been pleased with them. It seems we always misplace them, or can't find the ones we need, or grab the wrong ones, and they always seem to be covered in rust. For as many years as we've been doing this we've always been looking for a better way. After searching off and on for a solution to this nagging problem we finally have a workable solution. The PMA Micro Die Adjuster.
The PMA Tool Micro Die Adjuster (MDA) replaces your existing lock ring and can be used with nearly any 7/8-14 full length sizing die. We successfully used this tool with sizing dies from Redding, RCBS, Hornady, Lee, Harrells Precision and those made from Newlon Precision die blanks. It allows you to easily make adjustments to your “shoulder bump” as fine as .0005”. The engraved marks on the MDA are equal to approximately .001” (true adjustment .000992”) of adjustment to the shoulder bump. Splitting the engraved marks is therefore approximately equal to .0005”. The design of the MDA does not allow it to work with the Forster Co-Ax press and is not intended for use with turret presses, progressive presses or the RCBS Summit press. Some custom dies for very short cartridges may require the use of an extended shellholder.Micro Die Adjuster shown in use installed on Custom Newlon/Scott 6mm PPC Die and Harrells Precision Compact Press.
**Includes Thumb Screw Upgrade for locking the adjustment in place
60 Reviews
-
Follow the setup instructions, any adjustments after that are simple, to half a thou! Easy to get along with.
Very good tool!
-
PMA Micro Die Adjuster
The micro die adjuster is a joy to use. It makes sizing die adjustments a breeze and is easy to dial in .0005-.001” shoulder bump. The PMA crew is a pleasure to do business with and is happy to help with any questions or suggestions on equipment.
-
PMA Micro Die Adjuster
Great Quality! Product functions as advertised.
-
Perfect
Works as it should. Once you get it close to size it is very accurate in the measurement and is also repeatable. Best idea I have seen to make fine adjustments when sizing cases. If you have 2 calibers you want to use this on, just buy 2. Don’t try to switch between calibers. It works perfect on both my rcbs and Redding type s bushing dies.
-
Micro die adjust
Excellent this is my 3rd 1. Wish I had 1 on all my dies
-
Micro adjuster
Very nice setup for that "just right" brass bump back! This does an excellent job and is very consistent. Can't be beat!
-
PMA Micro DieSdjuster
Excellent, this is my second one. Great for getting headspace exactly and the repeatability is unbelievable. GREAT PRODUCT!!!’nnnn
-
easy to instal and use
When used with full-body necking dies it helps to better align case-neck centers and provides more consistent shoulder setbacks.
-
It's a good idea...but.
It's works but I took a long time to clean the threads so that it would work. The threads were machined with lots of metal fragments and dirt left. Impossible to adjust until it was cleaned and buffed. Hours lost. But once it was corrected it works fine.