PMA Tool

 Interchangeable cartridge family inserts for the PMA Micro-Adjust Trimmer.     Please select from the chart and drop down menu below when ordering.  If you have...

"Sure, it's straight, but can you make it straighter?"- That simple statement started us on the path to make perfection even better. Not all reloading presses are created equal. In fact, a lot of...

 For as long as we've been reloading we've always hated setting up our full length sizing dies. We've been using shims to help this along for quite a long while now, but have not really been...

For as long as we've been reloading we've always hated setting up our full length sizing dies. We've been using shims to help this along for quite a long while now, but have not really been pleased...

If you don't find your cartridge listed in our table of Case Trimmer Inserts and don't have access to the reamer for you rifle, we can make custom inserts using two fired and sized cases. To order,...

We've improved our Model A with an updated cutter with more relief to keep the mandrel cooler and be able to remove more brass faster. We've also updated the adjustment locking mechanism in order to...

We've improved our Model A with an updated cutter with more relief to keep the mandrel cooler and be able to remove more brass faster. We've also updated the adjustment locking mechanism in order to...

We've improved our Model A with an updated cutter with more relief to keep the mandrel cooler and be able to remove more brass faster. We've also updated the adjustment locking mechanism in order to...

The same Model A Neck Turning Tool, but will accept K&M neck turning pilots. WILL NOT ACCEPT PMA, SINCLAIR OR 21st CENTURY MANDRELS.   We've improved our Model A with an updated cutter...

We've improved our Model A with an updated cutter with more relief to keep the mandrel cooler and be able to remove more brass faster. We've also updated the adjustment locking mechanism in order to...

These are replacement cutters for our PMA Neck Turning Tools. If you want to convert your neck tool to a different shoulder angle or if you feel your existing cutter is losing its edge (not likely,...

While finishing the design of the Model A we developed the concept of an inexpensive, ergonomic and well-built neck tool. We wanted to be able to offer it with the cutting depth pre-set to a...